Sotto Lofi Manual
Overview
Sotto Lofi lowers the sample rate of your audio, the way early samplers and old digital gear did, for a dark, muffled, lo-fi sound. One knob does it: Rate. Turn it down for a heavier, more submerged sound, and up for a lighter touch.
Filters before and after the rate reduction remove the harsh, fizzy edge that plain sample rate reduction adds, so even the lowest settings stay smooth rather than gritty.
Changes to the Rate can be undone with Cmd+Z (Ctrl+Z on Windows) and redone with Cmd+Shift+Z or Cmd+Y. The info bar at the bottom explains whatever is under the mouse.
1. Rate
The Rate knob in the middle sets the sample rate your audio is reduced to, from 700 Hz to 36 kHz. The default is 4.4 kHz. The value is shown under the knob.
- Turning it: Drag up or right to raise the rate, and down or left to lower it. Hold Shift (or Cmd) while dragging for fine adjustment. The mouse wheel turns it too.
- Reset: Double click the knob to go back to 4.4 kHz.
- What you hear: The higher the rate, the more of the top end survives. At 36 kHz the effect is subtle, only rolling off the very top. At the default 4.4 kHz the sound is muffled and warm, and below 2 kHz it is dark and distant.
- Exact rates: The rate locks to a whole fraction of your project's sample rate, so the sound stays steady. For example, 4.4 kHz in a 48 kHz project plays at 4.36 kHz (48 kHz divided by 11).
- Automation: The Rate parameter can be automated in your DAW. Changes glide over a few milliseconds, so automation moves smoothly without clicks.
- No latency: The plugin adds no delay to your audio.
- Saved with your project: The Rate is saved with your project and with your presets. Each drag, double click or wheel turn is one undo step.
2. Presets
Presets are loaded and saved from the settings menu (click the SOTTOVOCE logo at the bottom right). Settings > Load Preset lists Default Preset under Default Presets and your own presets, in alphabetical order, under User Presets.
- Factory preset: Default Preset sets the Rate to 4.4 kHz.
- What a preset holds: The Rate.
- Saving: Settings > Save Preset asks for a name. If the name is taken, a number is added ("My Lofi 2"), so a preset is never overwritten. Loading or saving a preset clears the undo history.
- Where presets live: Settings > View Preset Folder opens the folder, which holds a Default Presets folder and a User Presets folder.
3. Settings
Click the SOTTOVOCE logo at the bottom right to open the settings menu.

- View Licence Agreement: Shows the EULA and copyright notice.
- View Licence Information: Shows the active licence information.
- View Manual: Brings you to this page.
- Load Preset: Loads a preset from the Default Presets or User Presets list.
- Save Preset: Saves the Rate under a name you choose.
- View Preset Folder: Opens the folder the presets are kept in.
- Scale-up Plugin Dimensions / Scale-down Plugin Dimensions: Shows the plugin at 100 or 150 percent. Scale-up is greyed out when the larger window would not fit on your display.
4. Audacity
Every time Audacity applies the effect, the plugin starts fresh, so nothing from the end of one pass carries into the start of the next.
